Drain Cable-End Conversion Adapters
FlowFixer FFA1 & FFA2
Ridgid ↔ General 5/8″ Cable-End Conversion — Steel, Snap-On
Stop hauling two machines. The FlowFixer adapter pair lets a single drain cleaner run both Ridgid and General cable-end tooling. FFA1 puts General slotted bits and cutters on Ridgid cable ends; FFA2 takes them back the other way. Machined steel, snap-on installation, one job at a time.
Which Adapter Do I Need?
FFA1: Ridgid to General Cable-End Adapter
Run General Slotted Tooling on a Ridgid Cable End
Converts Ridgid R-connector → General slotted
- Run General slotted bits and cutters on your Ridgid machine without carrying a second drain cleaner.
- Snap-on installation. The adapter clamps onto your existing 5/8″ cable end for a secure connection.
- Fits Ridgid 5/8″ cable ends on K40, K50, K375, K380, K400 and K3800 models.
- One toolkit, both connection styles. Reduce the time, storage space and cost associated with duplicate equipment.
FFA2: General to Ridgid Cable-End Adapter
Run Ridgid R-Connector Tooling from a General Slotted Cable End
Converts General slotted → Ridgid R-connector
- Adapt General slotted cable ends for Ridgid R-connector tooling—the reverse conversion of the FFA1.
- Compatible with E-FC-type female cable connectors.
- Snap-on installation onto a 5/8″ cable end provides a fast, secure setup with minimal downtime.
- Unify a mixed fleet. Use one machine across both connection systems instead of buying duplicate equipment.
Ridgid Machine Compatibility
Fits the 5/8″ cable-end connector style used with these Ridgid sectional and drum machine models:
Fast Installation in Three Steps
Confirm
Verify that your cable end uses the 5/8″ connector style. This measurement refers to the connector, not the cable diameter.
Snap On
Seat the FlowFixer adapter onto the existing 5/8″ cable end and confirm that the connection is secure.
Connect Your Tooling
With FFA1, attach a General slotted bit or cutter. With FFA2, attach Ridgid R-connector tooling.
RIDGID® and the Ridgid model designations K40, K50, K375, K380, K400 and K3800 are registered trademarks of RIDGID, Inc. or Emerson Electric Co. GENERAL® is a trademark of General Wire Spring Co. Pro-Graad is an independent brand and is not affiliated with, authorized, sponsored or endorsed by these companies. Brand and model names are used solely to indicate aftermarket cable-end compatibility. FlowFixer FFA1 and FFA2 are aftermarket adapters manufactured and sold by Dabynology, LLC.
